The following item must be safety wired, or secured in a manner approved by Tech:

- axles or axle nuts
- oil filler caps
- kickstarter retaining bolts
- axle caps and/or pinch bolts
- oil drain plug(s)
- removable exhaust baffles
- brake caliper bolts
- oil gallery plugs
- radiator caps
- brake torque arms
- oil lines
- coolant drains
- spin on oil filters/filter bolts
- any pressure fed lubricant line
- fork oil drain screws/bolts
- rear exhaust mount(s) (all)
- brake pad retaining pins

(may be secured by silicone glue in lieu of wiring)

Bike Requirements

All TMC competitors must wear helmets which have a Snell ’05 thru ‘20 approval sticker, or must be BSI or ECE approved and must be in good condition (as determined by Tech) and not manufactured more than 5 years prior to the date of the event. Helmets must be taken to Technical Inspection and must display a TMC Helmet Tech decal prior to being allowed on the track. Open-faced, modular, and dirt bike helmets are not allowed.

Footwear must be no less than 8 inches in height and must be leather. Gloves must be worn, and while leather is preferred, combinations of nylon and leather are acceptable, if leather protects the fingers and palms. Gloves and boots must be of a fit so there is no gap between them and the leathers.

Clothing must be leather, or a leather/cordura/kevlar stretch panel (in arms/legs) combination. All suits must be a one-piece garment for racing. Separate jackets and trousers are acceptable only if they zip together around the entirety of the waist to make one piece of clothing, pending approval of the Technical Inspector.

It is required that riders wear back protectors under their leather racing gear unless their racing gear is equipped with a back protector. Chest protectors are suggested. In general, riders are encouraged to use all available protective material which does not restrict safe operation of their machine.

1.







2.





3.






4.

Rider Requirements

Tech